Fluid Components International CMB - Manual (Page 18)

3.5 Operating conditions
3.5.1 Installation
The sensor is to be protected, wherever possible, against valves, manifolds and similar fittings that gen-
erate turbulence. The sensor is to be installed in accordance with the following instructions.
Diagram showing flowmeter installation
A
B C C C C
Flowmeter installation: A = sensor, B = valve, C = pipe clamps and supports
Under no circumstances is the
sensor to be used to support a
pipe.
Do not install the sensor in sus-
pended pipes.
Do not adjust the position of a
pipe by pulling or grasping the
sensor.
Page 18 of 106
CMB & CT OPERATING MANUAL