Fluid Components International FR73B Manual Installation - Manual

Doc. No. 06EN003281 Rev. - 2 - 1 Model FR78B Flow Switch/Monitor
CHAPTER 2 - INSTALLATION FLUID COMPONENTS INTL
2. Installation
Receiving/Inspection
• Unpack carefully.
• Verify that all items in the packing list are received and are correct.
• Inspect all instruments for damage or contaminants prior to installation.
If the above three items are satisfactory, proceed with the installation. If not, then stop and contact a customer
service representative.
Packing/Shipping/Returns
These issues are addressed in Appendix C - Customer Service
Factory Calibration Note
The instrument is factory calibrated to the flow range specified in the order. There is no need to perform any
verification or calibration steps prior to installing and placing the instrument in service.
Required Materials
Appropriate wire, cable, and conduit.
Note: Potting Y's for all the interconnecting wires are recommended when installing the instrument's
control circuit in an enclosure. Other requirements may vary based on local wiring codes.
Pre-Installation Procedure
Warning: Only qualified personnel should install this instrument. Install and follow safety procedures in
accordance with the current National Electrical Code. Ensure that power is off during
installation. Any instances where power is applied to the instrument will be noted in this
manual. Where the instructions call for the use of electrical current, the operator assumes all
responsibility for conformance to safety standards and practices.
Caution: Damage resulting from moisture penetration of the local or remote (optional) enclosure is not
covered by product warranty.
Verify Serial Numbers
Verify that the flow element serial number matches the control circuit serial number.