Brooks Instrument XacTorr CMX160 - Manual (Page 7)

p.1
1.0 SAFETY NOTICES
This manual provides information for the installation and operation of the Brooks
CMX Series Heated Digital Capacitance Manometers (CMs). It is imperative that
this manual be reviewed prior to installation and operation of the device. Failure
to comply with the warnings, cautions, and hazard notes will void the product’s
warranty. Use of these instruments in a manner other than those specified by
Brooks may result in injury or death and will void the product’s warranty. Brooks
assumes no liability for any damage resulting from the improper use of its
products.
1.1 SAFETY SYMBOLS
The following safety symbols are used throughout the system documentation:
CAUTION ! !
Procedure could cause equipment damage/failure or procedure malfunction if not
followed.
WARNING ! !
Not following the procedure or adhering to advice could result in severe equipment
damage and or environmental damage.
DANGER
Severe injury or injury resulting in death could result if stated or local procedures
are not followed.
1.2 GROUNDING
DANGER
SHOCK HAZARD. All devices must be properly grounded.
All devices must be properly grounded to reduce the risk of an electrical shock.
1.3 EXPLOSIVE ATMOSPHERE
DANGER
Do not use equipment in an explosive atmosphere.
The CMX family of products are NOT intended for use in explosive
atmospheres.
1.4 PART SUBSTITUTIONS AND MODIFICATIONS
WARNING ! !
Do not substitute parts or modify equipment.
Modifying an instrument in any way not only voids the warranty but could cause
a safety hazard and should be avoided. Repair work should be done at the
factory or by a factory-authorized service center.
1.5 GENERAL SAFETY GUIDELINES
CAUTION ! !
Always follow established industrial safety practices when operating any
production equipment.
CAUTION ! !
Safety is designed into every product. When followed, these minimum guidelines
provide an acceptable level of safety for operating and maintaining your system.
1.0
_INTRODUCTION