Brooks Instrument XacTorr CMX160 - Manual (Page 27)

p.21
Figure 22: 15-Pin “D” Connector Pinouts
3.7 DEVICENET CONNECTION
Set the DeviceNet baud rate selection switch (Located on top of the device) to
the desired baud rate. Set the address selection switches (Node Address) to the
desired address, noting the most significant digit and least significant digit
position. After these switches have been set, connect the DeviceNet power/
communication cable to the device. When power is applied, the unit will go
through an initialization procedure. The LED indicators will flash in sequence.
After this initial sequence, the Module Status LED should be green, the Network
Status LED should be flashing green (if network on-line, with no connection
established), and the Ready/Temperature status indicator should be:
• Amber – unit is warming up to the proper operating temperature.
PIN # PIN ASSIGNMENT
1 Temperature in control relay NO
2 Pressure signal
3 Temperature in control relay common
4 Temperature in control relay NC
5 Power supply common
6 -15 VDC
7 +15 VDC
8 Relay 1 - Normally OPEN
9 Relay 1 - Contact common
10 Relay 1 - Normally CLOSED
11 Relay 2 - Normally OPEN
12 Signal common
13 Relay 2 - common
14 Relay 2 - Normally CLOSED
15 Chassis ground
PIN # PIN ASSIGNMENT
1 Temperature in control relay NO
2 Pressure signal
3 Temperature in control relay common
4 Temperature in control relay NC
5 Power supply common
6 -15 VDC
7 +15 VDC
8 Relay 1 - Normally OPEN
9 Relay 1 - Contact common
10 Relay 1 - Normally CLOSED
11 Overheat Relay - Normally OPEN
12 Signal common
13 Overheat Relay - common
14 Overheat Relay - Normally CLOSED
15 Chassis ground
PIN # PIN ASSIGNMENT
1 Temperature status
2 Output signal
3 Remote ZERO trigger
4 No connection
5 External power supply common
6 -15 VDC
7 +15 VDC
8 Relay 1 - Normally OPEN
9 Relay 1 - Contact common
10 Relay 1 - Normally CLOSED
11 Relay 2 - Normally OPEN
12 Signal common
13 Relay 2 - Contact common
14 Relay 2 - Normally CLOSED
15 Chassis ground
Connector Option 5 (CMX160 only)
Connector Option 2
Connector Option 4 (CMX160 only)
CMX
Cable
15-Pin D Sub Male
15-Pin D Sub Female
3.0
_INSTALLATION