eLine Technology EYS-VMS eyStream User Manual Part1 - Manual (Page 85)

85
e. From the Port list, select the serial port used to connect to the GSM modem.
f. If hardware control of the serial port data protocol is enabled (see step 5.8) and you
need to use an RTS signal, select Yes from the RTS signal list.
g. Select the speed for data transmission via the GSM modem from the Baud rate list.
h. If you need to control the serial port data protocol, select the desired method of
control from the Handshaking list: hardware (RTS/STS), software (XOn/XOff), or
alternating.
6. Click the Apply button.
Configuration of the SMS object is now complete.
Checking SMS notifications
To check SMS notifications from an SMS message object, send a test message by clicking the Tes
t message button.
When you do this, the following message is sent to the mobile number indicated in the To field:
"This is a test message to check EyStream SMS notification."
Note
If the recipient does not receive the message, make sure that the settings of the
SMS object have been properly configured
Configuring the web server
To configure the web server in the EyStream software package:
1. Select a Server object.
eLineTechnology.com 303.938.8062