Creating the sms object, Configuring the sms object – eLine Technology EYS-VMS eyStream User Manual Part1 User Manual
Page 84

84
4.
Start the Server and Client. Create and configure an SMS object.
Creating the SMS Object
To create an SMS object, you must perform the following steps:
1.
In the list of devices, highlight a Server object (1)
2.
Click the
button (2).
3.
Click the Apply button.
4.
When you do this, the SMS object appears in the list of devices (3).
Creation of the SMS object is now complete.
Configuring the SMS Object
To configure an SMS object, you must perform the following steps:
1.
In the list of devices, highlight the SMS object which needs to be configured (1).
2.
Activate the SMS object (2) by selecting Yes in the Enable list.
3.
In the Name field (3) enter the desired name of the SMS object.
4.
In the To field (4), enter the cellular telephone number, in international format (+
5.
In the SerialPort settings group (5), indicate the port settings used to connect to the GSM
modem by which SMS messages will be sent:
a.
If you need to use a DTR control signal, select Yes from the DTR list.
b.
In the Bits field, enter the number of bits in the byte of a data packet.
c.
In the Stop bits length field, enter the number of bits in the stop bit of a data
packet.
d.
If you need to use a parity check when transmitting data, select the desired method of
parity check from the Parity list.
eLineTechnology.com
303.938.8062