Analog Way Smart MatriX User Manual

Page 35

Output selection settings

To set up the outputs, go in the

Output #1

Output

menu and choose first the appropriate

format/resolution, and then the appropriate rate for your screens by using the knob button and the

Enter button.

Output# → Output Format → Output rate

Use the native resolution of your screens/projectors in order to obtain the best image quality.

In the

Output

menu, you can also synchronise all the changes from the

Output

to the

Out-

put

by checking the case

Sync. w/Out 1

. It allows you to set up both outputs at the same time.

Output 2 → Sync. w/Out 1

Some other settings are available too:
-

The Output synch polarity.

The Gamma: use this feature to set up the output Gamma.

Flicker Filter (Video Out only): apply a flicker filter on your video output.

Analog type: set up the type of synchronisation of your Analog output.

DVI type: set up the type of color place of your Digital output.

HDCP detection: set up to enable/disable the HDCP detection on the output.

Background colour: add a background colour in place of the default black one.

Test pattern: use test pattern on Main or Preview screen to configure your projectors.

*All changes have to be validated by pressing the

ENTER button in order to be saved*

* NOTE *: The output status can provide you all information about the output in real time. This fea-

ture is particularly needed when HDCP is used thanks to the HDCP status.

Source output selection

Once your inputs all have been configured, the output settings of the

Smart MatriX must be set according to

the machines plugged on your

Smart MatriX main and preview outputs (video projector, preview monitor...).

* NOTE * : If you want to use HDCP content from your sources, be sure to attach HDCP compliant screens

or projectors. If it’s not the case, the output image could be disabled.

Input Sync. Loss Function

Allows to display a frame or a source in case of sync loss of the selected input. To set up the Sync. Loss

function:

Menu → Control → Sync. Loss → Press Input# or Enabled

The selected input must be activated for being visible in case of sync loss.