Advanced parameters and commands, Two-point correction (a, b, e, j, k, n), Chapter – ALLIED Vision Technologies Goldeye P-032 SWIR User Manual
Page 66: E current parameters see chap- ter, E chapter, Advanced parameters and, Commands
Goldeye Technical Manual V2.5.0
66
Advanced parameters and commands
This chapter illustrates the advanced configuration of the Goldeye xy-... mod-
els.
Two-point correction (A, B, E, J, K, N)
To configure the two-point correction, use the following parameters:
The parameter
E controls the operation mode of the two-point correction. The
following value assignments are valid:
Note
In most cases, the use of basic commands is sufficient.
In some cases you might need the following advanced
parameters and commands.
Parameter Description
A
File number of the first correction image recorded at low
reference temperature
B
File number of the first correction image recorded at high
reference temperature
E
Two-point correction operating mode
J
Set value of the correction image of the actual chosen correction
data set recorded at low reference
K
Set value of the correction image of the actual chosen correction
data set recorded at high reference
N
File number for the set values of all correction data sets
Table 32: Advanced parameters: two-point correction
Value
Description
0
Deactivated
Data are passed through transparently.
1
Activated
Correction data
A and B are used, with the set values
J and K of the actual correction memory page S.
Table 33: Parameter
E: values