Power supply (pin 1-4), Serial interface (pin 7, 8), Mode input (pin 9) – ALLIED Vision Technologies Goldeye P-032 SWIR User Manual
Page 38: Serial interface (pin 7, 8) mode input (pin 9)
Camera interfaces
Goldeye Technical Manual V2.5.0
38
This connector is intended for the power supply as well as for controlling the
camera by the user.
Furthermore some output signals are available, showing the camera state.
Power supply (pin 1-4)
The camera requires 12 V +5% DC. Current consumption depends on model. See
chapter
Serial interface (pin 7, 8)
By use of the serial interface at pin 7 and 8 the camera can be controlled exter-
nally via a RS232 COM port.
A simple terminal program (e.g. HyperTerminal) is sufficient for manually con-
trolling the camera.
Mode input (pin 9)
The mode input provides a method for switching the camera between the con-
tinuous operation and image-on-demand (IOD) mode using an externally
applied signal. This input has the same function as the camera control signal
CC4. For more information: see chapter
9
Mode Input
optocoupler
input
10 Trigger (Reset)
Input
-
optocoupler
input
11
+
12 Exposure Output -
optocoupler
output
13
+
14 Line Sync
Out
Active low
15 Frame Sync
Output
Out
Active low
Pin Signal
Direction
Level
Description
Table 18: Camera I/O connector pin assignment (Goldeye xy-...)