beautypg.com

Trigger input (cc1), Ee chapter, For more information: see chapter – ALLIED Vision Technologies Goldeye P-032 SWIR User Manual

Page 44

background image

Data interface

Goldeye Technical Manual V2.5.0

44

Pin assignment of Camera Link connector
(base configuration)

*: Instead of the serial interface over the Camera Link connection
(SerTC, SerTFG) the serial interface can be used via the RS232 signals of the
15-pin D-sub connector alternatively. In this case an additional data cable is
necessary.

Trigger input (CC1)

If the camera is in image-on-demand mode, the start of the exposure and the
exposure time is controlled with this signal.

As alternative trigger- and exposure control line the trigger input at pins 10 and
11 of the 15-pin D-sub connector is available. For more information: see chap-
ter

Trigger input (pin 10, 11)

on page 39. The two trigger sources are internally

combined with an OR gate.

By activating the CC1 input signal, the active exposure of the sensor starts with
and stays active as long as the CC1 input is active. The preset exposure time is
always rounded to a multiple of the line time from 32 μs (Goldeye xy-008) or
63.4 μs (Goldeye xy-032).

Pin

Signal

Pin

Signal

1

GND

14

GND

2

X0-

15

X0+

3

X1-

16

X1+

4

X2-

17

X2+

5

XCLK-

18

XCLK+

6

X3-

19

X3+

7

SerTC+ P*

20

SerTC- P*

8

SerTFG- P*

21

SerTFG+ P*

9

CC1-

22

CC1+

10

CC2+

23

CC2-

11

CC3-

24

CC3+

12

CC4+

25

CC4-

13

GND

26

GND

Table 19: Pin assignment: Camera Link connector (base)

Note

Activating the image-on-demand mode is mandatory to enable
exposure time control.

For more information: see chapter

IOD mode (CC4)

on page 48.

This manual is related to the following products: