ALLIED Vision Technologies Goldeye P-032 SWIR - Manual (Page 48)

Data interface
Goldeye Technical Manual V2.5.0
48
Gain (CC3)
With the camera control signal CC3 the camera gain can be switched. If CC3 is
logically 1 the camera works with a gain value of one.
If the CC3 port is logically 0 the gain value is set to 10 (Goldeye xy-008) or 20
(Goldeye xy-032).
IOD mode (CC4)
The camera control signal CC4 switches between the continuous free-running
operation with fixed exposure time of 10 ms /5.4 ms (Goldeye xy-008) or
33.3 ms (Goldeye xy-032) on the one hand and the shutter- and image-on-
demand operation on the other hand.
If CC4 is logically 0, the image-on-demand mode is set. The camera will output
one image for every exposure impulse it receives via trigger input (CC1 or opto-
coupler input).
If CC4 is logically 1, the camera operates in continuous mode. As a second input
signal pin 9 of the 15 pin D-sub connector also controls the IOD mode. If one of
these two inputs selects IOD mode, it overrides the continuous mode selection
of the other one.
GigE feature name
(CameraSpecialFeatures) Feature visibility Description
HighSpeedMode Beginner Turn on or off the high-speed mode with reduced
resolution
(320x256 @118 fps / 320x160 @186 fps)
Table 23: Camera special feature: High-speed mode
GigE feature name
(AnalogControls) Feature visibility Description
Gain Beginner This feature controls the selected gain as a raw
integer value.
Table 24: Camera special feature: Gain