B&K Precision 879B - Manual - Manual (Page 47)

45
procedure is used to overwrite previously stored
settings into memory.
Prevent Overwrite of Stored Settings
In the utility menu, the “ PuP” option default setting is
always “ PrE”. This represents “previous settings”.
Keeping this setting will prevent the meter from
overwriting previously stored settings for power-up
state. Therefore, when entering the utility menu, be
sure not to change to “ SEt” to prevent overwriting any
previously stored power-up settings.
Reset Default Settings (dEF)
The last option in the utility menu allows you to reset
the meter to default settings. When the primary
display shows “ dEF”, the secondary display will show
“ NO” by default. The meter will also default this
setting to “ NO” to prevent accidental reset of
instrument settings.
Default Setting: No
To reset the meter to default settings, first select the
“ dEF” menu option by using the use button to
browse through the utility menu. When the primary