B&K Precision 879B - Manual - Manual (Page 30)

28
the input sockets or terminals. As recording is
performed, maximum, minimum, and average values
will be stored after a brief moment. A beep tone will
sound once a recording has been stored.
Note: Subsequent beep tones may occur in this mode if
there are new values that are recorded. For example, if a
new maximum is detected, it will beep once again to indicate
that the new value has been stored. Any previously stored
values will be overwritten with the new recorded values.
Maximum Mode
In this mode, the “ MAX” indicator will be shown on display.
This indicates that the value in the primary display
represents the recorded maximum value.
Minimum Mode
In this mode, the “ MIN” indicator will be shown on display.
This indicates that the value in the primary display
represents the recorded minimum value.
Average Mode
In this mode, the “ AVG” indicator will be shown on display.
This indicates that the value in the primary display
represents the recorded average value. This average value
is obtained by taking the maximum and minimum recorded
values and taking the average of the two values.