Autel MaxiTPMS TS601 - Manual (Page 60)

58
Figure 6.24
3) If the test has been initiated by the vehicle, a confirmation
message will be displayed on the screen. (Figure 6.25)
Figure 6.25
 If the test has not been successfully initiated by the vehicle, a
message ―LINKING ERROR‖ shows up. Make sure the tool
and DLC are connected securely.
 Some vehicles do not allow scan tools to control vehicle
systems or components. If the vehicle under test does not
support the EVAP Leak Test, an advisory message is
displayed on the screen. (Figure 6.26)