Alpha Technologies Celltron Essential CTE-1200 AT; CTE-2200 AT; CTE-3200 AT - Manual (Page 31)

 25 
Figure 6. Attaching the cable
to a strap
Retesting jar posts or straps
Introduction
You can retest jar posts or straps if you get test results you think are not accurate. Test results can vary
due to factors such as operating conditions, site conditions, or manufacturer changes. If you accept
results under these conditions, your maintenance routine might not have an accurate history.
You can retest a set of jar posts or straps right after you test them, or you can test the rest of the site
before you retest certain jar posts or straps.
Retesting after testing the jar post or strap
To retest a set of jar posts or a strap just after you test it, press
RETEST while you are still connected.
The test results are displayed again for that jar post or strap.
In AUTO START , the retest will begin immediately.
Retesting after testing the site
To retest a set of jar posts or a strap after you have disconnected or after you test the entire site:
1. If still connected, remove the probes or clamps from the set of jar posts or strap.
2. Press and hold the
MENU button to turn on the analyzer.
CTE ALPHA
© 2003 MIDTRONICS
MIDTRONICS
1. SET PARAMETERS
2. TEST BATTERY
3. VIEW PARAMETERS
MENU