Alpha Technologies Celltron Essential CTE-1200 AT; CTE-2200 AT; CTE-3200 AT - Manual (Page 20)

 14 
Adjusting the screen contrast (H. CONTRAST)
To change the screen contrast:
1. Press  or  to scroll to H. CONTRAST in
the UTILITIES menu and press ENTER .
2. Press Press  to decrease or  to increase the screen shade.
Return to the main MENU (I. MAIN MENU)
Scrolling to this option and pressing
ENTER takes you back to the top, or main MENU.
Setting values in the SET PARAMETERS menu
Introduction
Before testing a site, you need to enter its test parameter values. Look at the test parameter settings
to determine whether they are correct for your application. If you do not set values for the site in this
menu, the analyzer uses the defaults when you test the site.
For information about the defaults and descriptions of the parameter values in the
SET PARAMETERS
menu, refer to “Menu options” in Chapter 1.
Note:
When you set the values in this menu for a site and then test batteries,
you cannot change settings without first deleting the test results for the site.
If you have set parameters for a site, or if you do not need to make changes and are ready to test it,
refer to “Chapter 3: Testing.”
Options
After you access the
SET PARAMETERS
menu, you can:
• Set system volts (1. SYSTEM VOLTS)
• Select the test points (2. JARS ONLY or JARS AND STRAPS)
• Set the site temperature (3. TEMP:)
• Set the reference value (4. REF:)
• Set the number of volts per jar
(5. VOLTS/BATTERY:)
• Select the manufacturer and model of the batteries to be tested (6. SELECT BATTERY)
• Return to main MENU (7. MAIN MENU)
LOWER HIGHER
TO SET
CONTRAST