ABUS FU8211 Secvest 2WAY Wireless Universal Module User Manual

Page 58

Close both tamper contacts of the WAM and wait until it emits a
double tone.

6.6

Factory default setting

To delete all settings in the accessory module and all detectors,
proceed as follows:
In the main programming menu, select item 8 (LED 8 lights up).
Confirm by pressing SET.
All LEDs flash.
Keep ESC/DEL pressed until the accessory module emits a double
tone as confirmation and LED 8 lights up. The programming and all
trained wireless detectors are now deleted.
Note: To exit menu item 8 without making a factory reset, only
press ESC/DEL briefly.
After restoring the factory default settings, exit the programming
mode by pressing ESC/DEL.
The LED for the power supply lights up/flashes and the fault LED
lights up. The accessory module beeps at short intervals.
Close both tamper contacts of the WAM and wait until it emits a
double tone.

7. Technical

data

Power supply:

12 V DC

Power consumption:

70 mA when idle

90 mA with activated relay
240 mA with activated relay and
battery charge

Emergency power supply: 6 V DC, 1.2 Ah
Number of channels:

Display:

10 LEDs

Outputs:

4 x transistor relays (NO/NC)
Max. switching power 500 mA,
24 V DC, R = 2

Ω

1 x RJ12 for triggering the sirens

Inputs: 2

Compatibility: Secvest

Terxon

Wireless smoke detector

Wireless motion sensor

Wireless magnetic contact

Wireless vibration detector
Wireless glass breakage detector

Remote

control

(FU5150/FU5155)