Extron Electronics USP 405 User Guide - Manual (Page 6)

Quick Start — USP 405, cont’d
USP 405 • Quick Start QS-4
5 Genlock menu
6 Exit menu
Picture Adjustments menu
Executive Mode menu
Advanced
Configuration
Horz Phase Sub
128 016
NEXT MENU
Genlock
NEXT
Horizontal phase
• 0 thru 255 Subcarrier phase
• 0 thru 255
5
Genlock
MENU
Exit
MENU
Default
Cycle
NEXT
Input
Configuration
6
Color Tint
101 114
Input
selection
button
Input #3
Composite
10 sec.
timeout
NOTE The horizontal Adjust knob and the vertical Adjust knob
are used to adjust the image settings on the left and
right sides of the LCD screen, respectively.
Default
Cycle
Select an Input button
Select a Picture Adjustment button COL/TNT
Power
on
Extron
USP 405 2 sec.
60-369-0x
Version x.xx 2 sec.
NOTE If the Test Pattern submenu in the Advanced Configuration
menu has been set to any pattern other than "Off", "Crop", or
a "Film aspect" crop pattern, the picture control adjustments
will be disabled ("Not Available").
NOTE With an input signal present, the following picture
adjustment(s) are "Not Available" for the
respective inputs with exceptions in ():
Input 1 : color and tint (not available anytime)
Input 2 : tint (but available only if S-video or composite is
selected and NTSC signal is input)
Input 3
: tint (but available only if an NTSC signal is input)
Input 4 : tint (but available only if an NTSC signal is input)
Input 5 : color, tint, and detail
10 sec.
timeout
Press for
2 seconds simultaneously*
Press for
2 seconds simultaneously*
Executive Mode
Enabled
Executive Mode
Disabled
10 sec.
timeout
*Executive mode can be enabled
or disabled from any menu
SIZE ZOOM SIZE ZOOM
Default
Cycle
Default
Cycle