Extron Electronics USP 405 User Guide - Manual (Page 28)

Installation and Operation, cont’d
USP 405 • Installation and Operation 2-12
Menus, Configuration, and Adjustments
USP 405 configuration and adjustments can be performed by using the
Windows-based control program (see chapter 3 for details) or by using the front
panel controls and the menus that are displayed on the USP’s LCD screen.
These menus are used primarily when the USP is first set up.
Moving through menus by using front panel controls
Menu button — Press the Menu button to activate menus and to scroll to the five
main menus.
Next button — Press the Next button to move between the submenus of a
selected main menu. Pressing the Next button during input configuration
causes the current input’s number and format type to be displayed on the
LCD.
Adjust ( , ) knobs — In configuration mode rotate the horizontal Adjust ( )
knob and vertical Adjust ( ) knob to scroll through submenu options and to
make adjustment selections. Refer to the flowcharts in this chapter and to
specific sections for explanations on knob adjustments.
Image adjustment buttons: Center, Size, Brt/Cont (brightness/contrast), Col/Tnt
(color/tint), Zoom, and Detail — When one of these buttons is pressed, the
corresponding image adjustment menu appears on the LCD screen.
Adjustments can then be made by rotating the horizontal Adjust (
) knob
or the vertical Adjust ( ) knob. Settings and adjustments are stored in
nonvolatile memory.
Menu overview
The default screens appear on the LCD when no adjustments are actively being
made. When the USP 405 is powered up, the LCD displays a screen showing the
USP model (USP 405/USP 405 I/ USP 405 O/ USP 405 IO) for approximately
2 seconds, then the model number and firmware version for approximately
2 seconds, and then the LCD cycles among screens showing the active input’s
number and video format, the input’s horizontal and vertical frequencies, and
the output resolution and refresh rate, as shown below.
Default menus
From any menu or submenu, after ten seconds of inactivity the USP 405
saves all adjustment settings and times out to the default screens.
The main menus are shown in the following flowchart. Use the Menu button to
scroll between them and the Next button to activate one for viewing or
configuration.
Default Cycle
60-369-0 x
Version x . xx 2 sec.
Input #1
RGBHV
Horz. 00.00 KHz
Vert. 00.00 Hz 2 sec.
2 sec.
Output Rate
1024 x 768 @ 60 2 sec.
Extron
USP 405 SDI O
Power
on
Extron
USP 405 SDI IO
Extron
USP 405 SDI I
2 sec.