beautypg.com

Installation and operation, Rear panel features, Power connection – Extron Electronics USP 405 User Guide User Manual

Page 20: Video input and output connections

background image

Installation and Operation

USP 405 • Installation and Operation

2-4

Rear Panel Features

The rear panel of the USP 405, as shown below, contains all of the possible
connectors available on the USP.

USP 405 rear panel connectors

Power connection

1

AC power connector

— Plug a standard IEC power cord into this

connector to connect the USP 405 to a 100 to 240VAC, 50 Hz or 60 Hz
power source. The front panel control and input selection buttons light in
sequence during power-up.

Video input and output connections

2

3

Video input 1

— RGB/computer video is input through the female

15-pin HD connector (

2

) and the input signal is also buffered and output

through a female 15-pin HD connector (

3

) for loop-through to a local

monitor. The RGB input can be scaled to 35 different output resolutions
and scan converted for YUV, YC, composite video, or SDI output.

Output of the SDI signal requires the SDI output card option.

4

Video input 2

— This input, consisting of 5 female BNC connectors,

accepts computer video (RGB), component video, composite video, and
S-video signals. The input can be scan converted for YUV, YC, composite
video, or SDI output. The output can be scaled to 35 different output
resolutions. Connect cables for the appropriate signal type, as shown in the
following diagram.

For 24 kHz to 100 kHz RGB signals, Input 2 can accept RGBHV, RGBS, or
RGsB formats when “RGB” is the selected input type (see
Input
Configuration on page 2-13).

For 15 kHz RGB signals (NTSC 3.58/PAL/SECAM/NTSC 4.43), Input 2
can accept RGBS or RGBcvS formats when “RGBcvS” is the selected input
type (see
Input Configuration on page 2-13).

The USP 405 does not accept any signal between 15.75 kHz and 24 kHz.

A 15.xx kHz input signal is converted properly only if the input is RGBS or
RGBcvS, but a 15.xx kHz RGBHV signal is not successfully converted.

2A MAX

100-240V 50-60Hz

REMOTE

RGB/HD R-Y, B-Y, Y

RGB/R-Y, B-Y, Y, YC, VID

R-Y, B-Y, Y

RGB

B-Y

R-Y

VID

SDI

SDI

Y

RGB/R-Y, B-Y, Y

S-VIDEO

S-VIDEO

VIDEO

5

4

3

2

VID

1

IN

R

/R-Y

G

/Y

B

/B-Y

H

V

S

R

/R-Y

G

/Y

B

/B-Y

H

/HV

V

OUT

G

E

N

L

O

C

K

O
U

T
P
U
T
S

I

N
P
U
T
S

Y

C

1

6

4

11

15

3

2

5

8

13

14

16

18

7

10

12

17

9