Extron Electronics USP 405 User Guide - Manual (Page 55)

A-3 USP 405 • Appendix
Connectors ................................... 1 x 6 BNC female (RGB, HD component video)
(1) 15-pin HD female (RGB, HD component video)
3 BNC female (component video)
(1) 4-pin mini DIN (S-video)
1 BNC female (composite video)
1 BNC female (optional SDI digital component video)
Nominal level ............................... 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
Minimum/maximum levels ....... 0 V to 2.0 Vp-p
Impedance .................................... 75 ohms
Scaled resolutions ........................ 640x480
1,3,4,6 , 800x600 1,3,4,6 , 832x624 3,4,6 , 848x480 3,6 , 852x480 3,6 , 1024x768 1,3,4,5,6 ,
1280x768 2,6 , 1280x1024 1,3,6 , 1360x765 3,6 , 1365x1024 3,6 , 1400x1050 1,3,6 , 576p 1,6 ,
720p 3,6 , 1080p 3,6 , 1080i 1,3,6 , NTSC, PAL
1 = at 50 Hz 2 = at 56 Hz 3 = at 60 Hz 4 = at 75 Hz 5 = at 85 Hz
6 = locked to the current input’s vertical refresh rate (up to 60 Hz) (Accu-
RATE Frame Lock)
Return loss .................................... -30 dB @ 5 MHz
DC offset ....................................... These data are for output with input at 0 offset:
±25 mV maximum for RGB
350±25 mV maximum for Y of component video/S-video, composite video
650±25 mV maximum for R-Y & B-Y of component video, C of S-video
Switching type .............................. Triple-Action
Sync
Input type ..................................... Autodetect RGBHV, RGBS, RGsB
Output type .................................. RGBHV, RGBS
Standards ...................................... NTSC 3.58, NTSC 4.43, PAL, and SECAM
Input level ..................................... 0 V to 5 Vp-p
Output level .................................. 0 V to 5 Vp-p, unterminated
Input impedance .......................... 510 ohms
Output impedance ....................... 75 ohms
Max input voltage ........................ 5 Vp-p
Polarity .......................................... Positive or negative (selectable)
Control/remote — switcher/scaler
Serial control port ........................ RS-232, 9-pin female D connector
Baud rate and protocol ............... 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations 2 = TX, 3 = RX, 5 = GND
Contact closure ............................ 9-pin female D connector
Contact closure pin configurations 1 = input 1, 4 = input 2, 6 = input 3, 7 = input 4, 8 = input 5
IR controller module ................... IR 801 (optional)
Program control .......................... Extron’s control program for Windows
®
Extron’s Simple Instruction Set (SIS ™ )
General
Power ............................................ 100 VAC to 240 VAC, 50/60 Hz, 30 watts, internal, autoswitchable
Temperature/humidity .............. Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +3° to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Rack mount .................................. Yes
Enclosure type .............................. Metal
Enclosure dimensions ................. 1.8" H x 17.5" W x 12" D (1U high, full rack wide)
4.6 cm H x 44.4 cm W x 30.5 cm D
(Depth excludes connectors and knobs. Width excludes rack ears.)