Extron Electronics USP 405 User Guide - Manual (Page 33)

2-17 USP 405 • Installation and Operation
Advanced Configuration
The following flowchart provides an overview of the Advanced Configuration submenus and
the options for each setting.
Output
Configuration
Advanced
Configuration
MENU
Edge Smoothing
OFF
NEXT
Encoder Filter
06
NEXT
Blue Mode
ON
Top Blanking Bot
021 030
NEXT
RGB Delay
0.2 Seconds
NEXT
NEXT
Either Adjust knob is used
to adjust the submenus*
To reset the scaler, press
and hold the Freeze button
until reset message displays
Smooth edges
• On (default)
• Off
Encoder filter setting
• 0 thru 12 (default is 6)
to adjust sharpness
RGB delay time
(in seconds)
• 0.0 to 5.0 seconds
in 0.1 sec. increments
(0.7 second default)
Display blue and sync only
• On
• Off (default)
NEXT
Press and Hold
FREEZE to Reset
NEXT
Test Pattern
Off
NEXT
Set test pattern type
• Off (default) • Alt pixel
• Color Bars • Film aspect 1.78
• Crosshatch • Film aspect 1.85
• 4 x 4 crosshatch • Film aspect 2.35
• Grayscale • Ramp
• Crop
Top and Bottom Blanking *
• Top blanking ranges from
000 (default) to 237
• Bottom blanking ranges
000 (default) to 237
Enhanced Mode
ON Enhanced mode (gain control)*
• On (default)
• Off
NEXT
PAL Film Mode
• On
• Off (default)
Input 2 PAL Film
ON
NEXT
NOTE Adjust knobs do not affect
this submenu.
* If the Test Pattern is set "On",
"Not Available" is displayed.
Edge Smoothing submenu
This submenu features edge smoothing. Edge smoothing smooths the edges of a
picture by minimizing the differences between pixels.
Using either the horizontal Adjust ( ) or vertical Adjust ( ) knob, select either
“On” or “Off”. The default is “On”.
Encoder Filter submenu
This submenu adjusts the sharpness of the displayed image. The sharpness can
be set from 0 to 12 (maximum). The default is 6.
Using either the horizontal Adjust ( ) or vertical Adjust ( ) knob, adjust the
filter for the desired sharpness level.
Blue Mode submenu
To aid in setup of the USP 405’s color and tint, the Blue Mode can be set from this
submenu to “On” so that only sync and blue video signals will be passed to the
display. Use either the horizontal Adjust (
) or vertical Adjust ( ) knob to
specify this mode. The default is “Off”.
Test Pattern submenu
In this submenu, several test patterns are provided to help adjust the display
device for color, convergence, focus, resolution, contrast, grey scale, and aspect
ratio. Use either the horizontal Adjust (
) or vertical Adjust ( ) knob to select a
test pattern. The options are: Off, Color Bars, Crosshatch, 4 x 4 Crosshatch,
Grayscale, Crop, Alternating Pixel, Film Aspect Ratios 1.78/1.85/2.35, and
Ramp. The default is “Off”.
The Alternating Pixel and Ramp test patterns are not available for NTSC or
PAL output rates. If one of these patterns is on when the output rate is
switched to NTSC or PAL, the test pattern changes to color bars.