Extron Electronics USP 405 User Guide - Manual (Page 23)

2-7 USP 405 • Installation and Operation
USP 405
UNIVERSAL SIGNAL PROCESSOR
ADJUST
MENU
NEXT
FREEZE 1 2 3 4 5
PICTURE ADJUSTMENTS
CENTER SIZE BRT/CONT COL/TNT ZOOM DETAIL
INPUTS
RGB UNIVERSAL FREEZE COMPOSITE S-VIDEO SDI
2 3 4 5 6 7 8 9 10 11 12 13 14 16 15 17 18 1
USP 405 front panel
1 Infrared sensor — This sensor is used to receive infrared (IR) signals from
the IR 801 remote control. See the “IR 801 Infrared Remote Control” section
in this chapter.
2 Freeze button — This button locks the output display to the current image
being input. When the freeze function is enabled, this button lights red. To
unfreeze the image, press the Freeze button again.
Input selection buttons
The input selection buttons select the video signal type being input. When
pressed, these buttons light yellow.
3 RGB input button — This button selects RGB computer video input from
video input 1.
4 Universal input button — This button selects either RGB video, component
video, S-video, or composite video input from video input 2.
5 Composite video input button — This button selects composite video
input from video input 3.
6 S-video input button — This button selects the S-video input from video
input 4.
7 SDI input button (serial digital interface) — This button selects the SDI
input from video input 5.
Actual input of the SDI signal requires the SDI input card option.
Picture adjustment buttons
The picture adjustment buttons select image adjustment controls that are
adjusted using the horizontal Adjust (
17 ) and vertical Adjust ( 18 ) adjustment
knobs. When pressed, these buttons light green.
8 Center control button — This button selects the centering adjustment for
the output display. The horizontal centering adjustment is made using the
horizontal Adjust knob and the vertical centering adjustment is made using
the vertical Adjust knob. There is no specified adjustment range. See the
“Image Adjustments” section in this chapter.
9 Size control button — This button selects the size adjustment for the
output display. The horizontal sizing adjustment is made using the
horizontal Adjust knob and the vertical sizing adjustment is made using
the vertical Adjust knob. There is no specified adjustment range. See the
“Image Adjustments” section in this chapter.
10 Brightness/Contrast control button (Brt/Cont) — This button selects the
brightness and contrast adjustment for the output display. The adjustment
is made using the horizontal Adjust and vertical Adjust adjustment knobs.
The adjustment range of brightness is 0 to 63, and contrast is 0 to 255. See
the “Image Adjustments” section in this chapter.