beautypg.com

Test the system – Extron Electronics PoleVault Systems PVS 305SA User Manual

Page 37

background image

2-26

PoleVault Systems Installation • Installation — Stage 5

3. Test the system

a.

Connect all the input devices (e.g., PC, DVD, document

camera, etc.) to the transmitters and power up the input

devices. Check that power and signal are present at the

transmitters. The LEDs light red when only power is

present and light green when power and a signal are

present.

b.

At the MLC 104 IP Plus, turn on the Display. Once the

the projector is powered up, check with an active video

source (PC or DVD) that a good image is shown on

screen.

N

Check the MLC controller configuration and

wiring if the display does not turn on.

c.

Properly align and adjust projector settings as follows:

• Adjust the rotation (yaw) by turning the unit on the

projector pole. Secure the location by tightening the

two set screws on the UPB mount plate to the pole

(see below).

• Loosen all pivot screws and adjust the vertical angle

(pitch) of the projector. Lock down the four

adjustment screws.

• Adjust the horizontal tilt (roll) of the projector. Lock

down all the remaining adjustment and pivot screws.

• Adjust the image settings on the projector (zoom,

focus, keystone, brightness, contrast, etc.). Refer to

the manufacturer’s user manual.

3c

Check that an image is present, adjust

as needed.

Pitch/Vertical Angle

Roll/Tilt

Pitch/Vertical Angle

Yaw/Rotation

Roll/Tilt

Vertical
Angle Adjustment
and Pivot
Point Screws

Horizontal Angle
Adjustment and
Pivot Point Screws

Adjuster
Plate Locking Screws (4)

Tighten these 2 set screws
(one each side) to lock the
UPB onto the pole.

3b

Connect and turn on the input devices,

and turn on the display at the MLC