beautypg.com

Finish projector drop ceiling mount installation – Extron Electronics PoleVault Systems PVS 305SA User Manual

Page 17

background image

2-6

PoleVault Systems Installation • Installation — Stage 1

6. Finish Projector Drop Ceiling Mount

installation

a.

Detach the projector bracket/projector from the adjuster

plate. Do not remove the projector bracket from the

projector.

b.

Unscrew the UPB 25 adapter plate from the mounting

pole.

c.

Loosen the set screws on the PCM 340 and the pipe

location screw and remove the mounting pole, then

loosen the T-frame securing screws and remove the

PCM 340 from its marked location.

d.

Replace the cut ceiling tile, checking its orientation to

align the hole with the PCM 340.

e.

Replace the PCM 340 over the ceiling tile, slide the

slotted pipe up through the tile and into the adapter

plate. Realign the location holes with the pipe holes,

insert and tighten down the location screw. Tighten the

set screws.

f.

Tighten the four T-frame securing screws on the

PCM 340. The T-frame securing screws can be used on

either side of the frame.

7. Secure the Projector Drop Ceiling Mount

to the ceiling

a.

Attach the four turnbuckles to the mounting plate, one at

each corner.

C

DO NOT rest or lean on the mounting plate or

suspended ceiling when attaching turnbuckles,
tie wire, or when drilling into the ceiling

N

For safest installation, insert the turnbuckle from

the outside so that it hooks inwards.

b.

Cut four equal lengths of the supplied hanging wire, and

loop the wire through the anchors or lag eye bolts, and

the turnbuckles, then twist the wire around itself at least

five times tightly at each end.

c.

Hand tighten the turnbuckles and level the plate so it just

rests on the T-frame.

C

The four hanging wires should be taut, taking

the full weight of the completed installation.

Do not overtighten the turnbuckles or the

T-frame assembly could be lifted, making the

suspended ceiling bowed and unsafe.

d.

Pass the braided safety cable through the fifth and center

anchor and attach it to the center holes on either side

of the plate. Ensure the cable is of equal length on both

sides of the anchor and secure the cable using the cable

clamps.

7a

Attach turnbuckles at the corners

6e

Slide the pipe through the ceiling tile

and into the pipe adapter plate

PCM

T-frame

Adjust the turnbuckles to take
up any slack in the hanging wire.

Secure PCM to frame
(from either side)

7c

Hand tighten the turnbuckles