Extron Electronics PoleVault Systems PVS 305SA - Manual (Page 13)

PoleVault Systems Installation • Installation — Stage 1 2-2
Stage One — Install the Screen and Projector
Stage 1
This stage involves installing the three pieces of hardware shown below.
Slotted
Pipe
Slotted Pipe
(supplied with PCM 340)
Where it goes: Attaches to structural ceiling, rests on
suspended ceiling.
What it does: Holds slotted pipe, PoleVault pole
mount kit (PMK 550 - see Stage 4), and
projector.
Where it goes: Locks into place in
PCM 340 pipe adapter.
What it does: Holds pole mount kit and
projector.
360° Movement
Projector Securing
Screw
Threaded
Barrels (4)
Arm Adjustment
Screws (4)
Adjuster Plate
Locking Screws (4)
Security Flange
(on rear)
Projector Bracket
(Bottom Section)
Adjuster Plate
(Top Section)
Pivot Point Screws (4)
Horizontal Angle
Adjustment Screws (4)
Set Screws (2)
Security Flange
(on rear)
Vertical Angle
Adjustment
Screws (4)
Pivot
Point
Screw
UPB 25 Universal Projector Bracket (shown separated into the two sections)
Where it goes: Adjuster Plate screws onto base of slotted pipe, and Projector Bracket attaches to projector.
What it does: Attaches projector to PCM 340. Allows projector orientation to be adjusted in three planes.
PCM 340 Projector Drop Ceiling Mount
T-frame
Securing
Screws (4)
1-gang and 2-gang Accessory Mounting
Points (e.g., Power Sockets)
Pipe Adapter Plate
Wing Nuts (4)
Pipe
Adapter
Base
Plate
Pipe Adapter
Set Screws (2)