Extron Electronics IPL T PC1i User Guide - Manual (Page 70)

Part Numbers and Accessories
Included Parts
These items are included in each order for an IPL T PC1 or IPL T PC1i interface:
Included Parts Part Number
IPL T PC1 60-544-10
IPL T PC1i 60-544-20
Rubber feet (self-adhesive) (4)
2-pin female captive screw terminal (2)
4-pin female captive screw terminal (1)
18 AWG IEC power cord (U. S. shipments only)
Tweeker (small screwdriver)
IPL T PC1 Setup Guide
IPL T PC1 Software CD-ROM
Optional Accessories
These items are optional for the IPL T PC1 and the IPL T PCli:
Optional Accessories Part Number
RSU 129 Universal Rack Shelf Kit (9.5 inches deep) 60-190-01
RSB 129 Basic Rack Shelf (9.5 inches deep) 60-604-02
RSU 126 Universal Rack Shelf Kit (6 inches deep) 60-190-10
RSB 126 Basic Rack Shelf (6 inches deep) 60-604-11
MBU 125 1/2 Rack Width Low-Profile Mount Kit 70-077-01
Mounting the IPL T PC1 Interface
The IPL T PC1 can be set on a table, mounted on a rack shelf, or mounted under furniture
such as a desk, podium, or tabletop.
Tabletop Use
Four self-adhesive rubber feet are included with the PC1. For tabletop use, attach one foot
at each corner of the bottom side of the unit, and place the PC1 in the desired location.
Rack Mounting
Rack mount the interface, if desired, using one of the optional 19 inches wide rack shelves
(see “
Optional Accessories ,” above, for part numbers).
UL requirements for rack mounting
The following Underwriters Laboratories (UL) requirements pertain to the installation of the
interface into a rack.
• Elevated operating ambient temperature — If the equipment is installed in a closed
or multi-unit rack assembly, the operating ambient temperature of the rack environment
may be greater than room ambient temperature. Therefore, consider installing the
equipment in an environment compatible with the maximum ambient temperature
(TMA) specified by the manufacturer.
IPL T PC1 • SIS Programming and Control 64