Extron Electronics IPL T PC1i User Guide User Manual
Page 64
Command
ASCII (Telnet)
(Host to Switcher)
URL Encoded (web)
(Host to Switcher)
Response
(Switcher to Host)
Password and Security Settings
Set administrator password
24
E
X3#
CA
}
W
X3#
CA
|
Ipa
•
X4!
]
Clear administrator password
24
NOTE:
A user password cannot be assigned if an administrator password does not exist. If the administrator password is
cleared (removed), the user password is also removed.
E•
CA
}
W
%20
CA
|
Ipa
•]
View administrator password
24
E
CA
}
W
CA
|
X4!
]
Set user password
14, 24
E
X3#
CU
}
W
X3#
CU
|
Ipu
•
X4!
]
Clear user password
24
E•
CU
}
W
%20
CU
|
Ipu
•
]
View user password
24
E
CU
}
W
CU
|
X4!
]
Query session security level
E
CK
}
W
CK
|
X5@
]
With tagged response –
verbose modes 2 and 3:
Pvl
X5@
]
NOTES:
•
The
]
Password prompt requires a password (administrator level or user level), followed by a carriage return.
The password prompt appears only if there is a password defined on the unit.
•
The copyright information displayed upon connection to the IP Link product via TCP/IP or Telnet is followed by
the password prompt.
•
The
]
Password prompt is repeated if a correct administrator or user password is not entered.
•
If a correct administrator or user password is entered, the unit responds with
]
Login Administrator
]
or
]
Login User
]
, depending on the password that was entered. If the administrator and user passwords are
the same, it defaults to administrator privileges.
Remapping Port Designations
NOTE:
Duplicate port number assignments are not permitted; that is, Telnet and web cannot be the same. Entering
duplicate port assignments results in an E13 (invalid parameter) error message.
Set Telnet port map
24
E
port
number
MT
}
W
port
number
MT
|
Pmt
port
number
]
Reset Telnet port map
24
E
23MT
}
W
23MT
|
Pmt
00023
]
Disable Telnet port map
24
E
0MT
}
W
0MT
|
Pmt
00000
]
View Telnet port map
E
MT
}
W
MT
|
port
number
]
Set web port map
24
E
port
number
MH
}
W
port
number
MH
|
Pmh
port
number
]
Reset web port map
24
E
80MH
}
W
80MH
|
Pmh
00080
]
Disable web port map
24
E
0MH
}
W
0MH
|
Pmh
00000
]
View web port map
E
MH
}
W
MH
|
port
number
]
Set Direct Access port map
24
E
2001MD
}
W
2001MK|
Pmd
02001
]
Disable Direct Access port map
24
E
0MD
}
W
MD
|
W
0MD
|
View Direct Access port map
E
MD}
WMD|
port
number
]
NOTE:
Remapping a port number (other than to reset it to the default 80 or 23, or to disable it by setting it to 0) must be
to port number 1024 or higher.
IPL T PC1 • SIS Programming and Control
58