Extron Electronics IPL T PC1i User Guide - Manual (Page 25)

3. On the Local Area Connection Properties window, select
Internet Protocol (TCP/IP) , then click the Properties button. If
Internet Protocol (TCP/IP) is not on the list, you must install it (see the Windows
user manual or the Windows online help system for the procedure).
Figure 13. Internet Protocol (TCP/IP) Selected on Local Area Connection
Properties Window
4. Write down the current IP address and subnet mask of your computer below. You will
need to restore these settings to the computer later.
If the
Obtain an IP address automatically radio button has been selected, make a
note of that.
5. On the Internet Protocol (TCP/IP) Properties window, change your computer IP address
temporarily so that it can communicate with the PC1:
a. Select the “ Use the following IP address ” radio button.
b. Enter the following values as shown below:
IP address: 192.168.254.253
Subnet mask: 255.255.0.0
Default gateway: Blank or 0.0.0.0
(The temporary IP address differs from the PC1 factory default by 1 digit.)
IPL T PC1 • HTML Configuration and Control 19