Extron Electronics IPL T PC1i User Guide - Manual (Page 68)

Reference
Material
Specifications
AC control interface
Connectors
IPL T PC1 ................................. 1 female USA/Edison power connector
IPL T PC1i ................................ 1 female IEC power connector
Voltage
IPL T PC1 ................................. 120 VAC, 50-60 Hz
IPL T PC1i ................................ 220 VAC, 50-60 Hz
Maximum AC load
IPL T PC1 ................................. 12 A, 1440 watts at 120 VAC
IPL T PC1i ................................ 10 A, 2200 watts at 220 VAC
Serial control interface
Serial control port ........................... (1) RS-232 only, 3.5 mm captive screw connector, 4 pole
Baud rate and protocol ................... 115200 to 300 baud (9600 baud = default) ; 8 (default) or 7 data bits; 1(default)
or 2 stop bits; no parity (default), or even or odd parity
Serial control pin configuration ....... 1 = Tx, 2 = Rx, 3 = GND, 4 = +5 VDC
Ethernet control interface
Connector ...................................... 1 female RJ-45 connector
Data rate ........................................ 10/100Base-T, half/full duplex with autodetect
Protocols ........................................ ARP, ICMP (ping), IP, TCP, UDP, DHCP, HTTP, SMTP, Telnet
Default settings .............................. Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Gateway = 0.0.0.0
DHCP = off
Web server ..................................... Up to 200 simultaneous sessions
7.25 MB nonvolatile user memory
Program control ............................. Extron Simple Instruction Set (SIS ™ )
Global Viewer requirements ........... Microsoft ® Internet Explorer ver. 6 or higher
Contact closure interface— input only
Quantity/type ................................. 1 contact closure input
Contact input control connector ..... (1) 3.5 mm captive screw connector, 4 pole (shared with IR output port)
Contact closure (input only)
Input voltage range ................. 0 to 5 VDC, clamped at +5.1 V
Input impedance ...................... 10k ohms
Threshold ................................. 1.6 VDC
Pin configuration ............................ 1 = contact input, 2 = GND
62 IPL T PC1 • SIS Programming and Control