Extron Electronics DSC HD-3G A User Guide - Manual (Page 54)

X6) = EDID file data block, 128 or 256 bytes of binary data (machine-readable only).
X6! = Video signal status
0 = Video (DSC 3G-HD A) or TMDS (DSC HD-3G A) signal not detected
1 = Video or TMDS signal detected.
X6@ = Power Save mode
0 = Full power mode (default)
1 = Low power mode
X6# = Screen saver status
0 = Active input detected, timer not running
1 = No active input detected, timer running, output sync active
2 = No active input detected, timer expired, output sync disabled
X6$ = Input lock (AFL) — DSC 3G-HD A only
0 = Disable input lock. Free running pixel clock is generated internally. (Default)
1 = Enable input lock. Locks output vertical to vertical refresh rate of the selected input.
X6% = Input lock (AFL) status — DSC 3G-HD A only
0 = Input lock (AFL) is disabled.
1 = Input lock (AFL) is enabled, but cannot lock to applied input signal. The DSC 3G-HD A
defaults to the set output rate.
2 = Input lock (AFL) is enabled. The output is locked to the applied input signal (AFL).
X6^ = Input lock (AFL) / SDI Genlock — DSC HD-3G A only
0 = Disable input lock/genlock. Free running pixel clock is generated internally. (Default)
1 = Enable input lock (AFL). Locks the output vertical to the vertical refresh rate of the
selected input.
2 = Enable SDI genlock. Locks output vertical to selected genlock input.
X6& = Input lock (AFL) / genlock status — DSC HD-3G A only
0 = Input lock (AFL) / SDI genlock is disabled.
1 = Input lock (AFL) is enabled, but cannot lock to the applied input signal. The
DSC 3G-HD A defaults to the set output rate.
2 = Input lock (AFL) /SDI genlock is enabled. The output is locked to the applied input
signal (AFL).
DSC 3G-HD A and DSC HD-3G A • Remote Configuration and Control 48