Xylem OxiTopIS OC100 - Manual (Page 30)

Operating Mode: Standard BOD Operating Mode: Standard BOD
30 BA31114e5 07/2006 BA31114e5 07/2006 31
Confirm the selected
measurement range for the
sample. The automatically
assigned sample number
(YY/MM/DD and sequential
number) is given in the header
line.
Additional information:
Type of measurement, run time, measurement range, final date, Id
number.
“Temp“ display => the AutoTemp function (see the chapter
“GLP/Tools”) is switched on.
Change the Id number for the additional identification of the sample
(e.g. extraction location) as follows:
- Use to move the cursor to the Id number,
- Press and
- Use to set the Id number required
(setting range 001 ... 255).
- Use to confirm this.
Use to print out the entire sample information
possible (see the chapter “Standard BOD - Print”).
Confirm the start of
measurement.
Contact selection:
The controller repeatedly sends the start information in the scanner
mode until successful feedback is received from the OxiTop®-C
measuring head. After the successful start message from the
measuring head:
Displays “!Started!”. From this
point in time, the sample exists
within the sample management.
Subsequently, the request to
start the next measuring head is
made automatically.
Start the next measuring head
(
2).
Contact selection:
The number of the measuring
head is automatically
incremented.
The controller continues to work with the stirring selection, i.e. you
can now start a sequence of measuring heads (parallel sample start)
without having to press any further keys by holding the controller to
the next measuring head to be started.
When all the measuring heads provided for this sample have been started:
Use to selecct “Stop start”:
The controller returns to the input menu.
If no measuring head is started (e.g. because the controller was not held to - or not
close enough to - a measuring head):