Xylem OxiTopIS OC100 - Manual (Page 15)

Operating Mode: Routine BOD Operating Mode: Routine BOD
14 BA31114e5 07/2006 BA31114e5 07/2006 15
Displays “Started“. From this point in
time, the sample exists within the
sample management. Subsequently,
the controller returns automatically to
the input menu.
If no sample starts (e.g. because the controller was not held to - or not
held close enough to - a measuring head):
The sample start was stopped.
Use to confirm
“Continue start“ and hold the
controller to the measuring head
(see above).
Use “Stop start“ if you want to
return to the entry menu.
If an attempt is made to start an already started sample:
Display shows “Measuring head
already used!”
Use to confirm “New
” and hold the controller to the
measuring head (see above).
Use “Stop start“ if you want to
return to the entry menu.
In the delivery state, the controller automatically makes space when
“Start
” is selected if the measured value memory is full. To do this, it
erases the oldest finished sample (if a finished sample is available). You
can change this setting in “manual erase” (see the chapter “GLP/Tools -
Settings”).
Call up all data
This function is used to call up the data of all measuring heads.
For the call up of the data of individual measuring heads: see the chapter on sample
management.
Entry menu “Communication with
the measuring heads“.
Use
to select “Call up all data“.
Point the controller at the measuring
heads: 40 cm to 100 cm
Queries the data of all active
measuring heads in the scanner
mode.
The controller stores the data
obtained and updates the list of
the sample management.
Duration of a pass: approx. 3
seconds for 12 measuring heads
in a stirring system.