Asus GigaX2048 - Manual (Page 72)

60
GigaX2024/2048 L2 Managed Switch User Manual
5.3.2 Physical Interface Commands
[Admin] [Enable/Disable]
Displays the port admin status, allow user to turn the port on or off.
CLI command: l2 port admin
[Mode] [Auto/10M-Half/10M-Full/100M-Half/100M-Full/1G-Full]
Displays the current speed and duplex mode of the port. The speed and duplex
mode can be automatically detected when auto-negotiation is enabled on a port.
CLI command: l2 port autoneg
CLI command: l2 port speed <10/100/1000>
CLI command: l2 port duplex
[Flow Control] [Enable/Disable]
Displays the IEEE802.3x flow control setting of a port. Note that this flow control
is operating only in full duplex mode.
CLI command: l2 port flow
[Reload]
Restores the previous port settings from the configuration file.
CLI command: l2 port retrieve
5.3.3 Bridge Commands
[Spanning Tree is] [STP Enabled/ RSTP Enabled/ Disabled]
Allows user to specify whether the switch participates the Spanning Tree
Protocol (STP/ RSTP).
CLI command: l2 stp start
CLI command: l2 stp stop
[Hello Time]
[Forward Delay]
[Max Age]
[Bridge Priority]
Displays the current STP/RSTP bridge parameters setting.