Net Optics iTap 10 GigaBit Port Aggregator User Manual
Page 51
iTap 10 GigaBit Port Aggregator
47
The following table describes each available configuration option.
Field Name
Description
IP Address
IP address of the iTap. The default IP address is 192.168.1.2.
Change the IP address by typing a new IP address in the
text box. This is the address for Web Manager and System
Manager to communicate with the device.
Net Mask
Displays current Net Mask of the iTap device. The default
Net Mask is 255.0.0.0. Change the IP address by typing a
new Net Mask in the text box.
Manager IP Address IP Address of the system management computer running
over a WAN. SNMP traps go to this address. Change the IP
address by typing a new IP address in the text box.
Gateway IP Address Displays current IP Address of the current WAN Gateway.
Change the Gateway by typing a new IP address in the text
box.
Port 1 Enable
Select
ON to enable the laser for Monitor Port 1.
Port 2 Enable
Select
ON to enable the laser for Monitor Port 2.
Port A Utilization
Threshold (%)
Enter the utilization level that will trigger a threshold alarm
for Port A.
Port B Utilization
Threshold (%)
Enter the utilization level that will trigger a threshold alarm
for Port B.
Port 1 Utilization
Threshold (%)
Enter the utilization level that will trigger a threshold alarm
for Port 1.
Port 2 Utilization
Threshold (%)
Enter the utilization level that will trigger a threshold alarm
for Port 2.
Reset Port A Peak
Rate
Select
Yes to reset the Peak data for Port A.
Reset Port B Peak
Rate
Select
Yes to reset the Peak data for Port B.
Reset Port 1 Peak
Rate
Select
Yes to reset the Peak data for Port 1.
Reset Port 2 Peak
Rate
Select
Yes to reset the Peak data for Port 2.
Reset Port A
Statistics
Select
Yes to zero all counters for Port A.
Reset Port B
Statistics
Select
Yes to zero all counters for Port B.