Net Optics iTap 10 GigaBit Port Aggregator User Manual

Page 20

iTap 10 GigaBit Port Aggregator

Using the CLI Help Command

To view CLI help information:

1. Enter Help at the "NetOptics:" prompt. The list of help topics is displayed.

NetOptics: help

*************************************

* Net Optics Command Line Interface *

*************************************

Usage: "help "

set - Configure various options.

reset - Reset options.

show - Show current configurations and status.

echo - Turn on or off echoing of characters.

help - This help screen.

NetOptics:

Figure 7: iTap Port Aggregator CLI Help Menu

2. To view the syntax for changing the iTap Port Aggregator configuration param-

eters, enter help set.

3. Repeat with the command of interest to view the syntax for all commands

available from the CLI. You can also enter a command and one of its

parameters.
Example: Enter help set threshold to see the usage of that command.

For a complete listing of CLI commands, see Appendix B.

Do not disconnect the DB9 cable from the RS232 port yet. You will use it again to

turn the iTap Port Aggregator front panel display on and off.