Unpack and inspect the itap port aggregator, Install xfp monitor port modules, Itap 10 gigabit port aggregator – Net Optics iTap 10 GigaBit Port Aggregator User Manual
Page 12: Figure 1: installing xfps
iTap 10 GigaBit Port Aggregator
8
Unpack and Inspect the iTap Port Aggregator
Unpack the iTap Port Aggregator and check for damaged or missing parts. The
iTap ships with the following:
• iTap 10 GigaBit Port Aggregator
• Two power supplies with cords
• iTap 10 GigaBit Port Aggregator Quick Install Guide (one sheet)
• iTap Software CD
• iTap 10 GigaBit Port Aggregator User Guide (this document, on the iTap Soft-
ware CD)
• Network and monitor cables
• RS232 DB9 cable for use with the CLI
• Extended Warranty if purchased
You may have also ordered rack unit panel for rack mounting the iTap. Carefully
check the packing slip against parts received. If any part is missing or damaged,
contact Net Optics' Customer Service immediately at +1 (408) 737-7777.
(Note: XFP modules are ordered and shipped separately.)
Install XFP Monitor Port Modules
XFP modules are shipped separately. Remove the temporary plugs from the iTap
Port Aggregator monitor slots and insert the XFP modules as shown below, until
they click into place. The photograph on the cover of this Guide shows properly
installed XFPs.
Figure 1: Installing XFPs
www.netoptics.com
Port Aggregator
2
1
B
A
2
1
B
A
LINK
TAP
AGG.
2
1
Mode
RESET
LASER
CAUTION!
OUT
OUT
IN
IN
OUT
IN
OUT
IN
Network
Monitor
A
B
1
2
10 GigaBit
TM