Net Optics iTap 10 GigaBit Port Aggregator User Manual

Page 35

iTap 10 GigaBit Port Aggregator

hange iTap Port Aggregator System Configuration

Web Manager has both read‑only and writable fields. Use the writable fields in

the Aggregator System Configuration section to set configuration parameters. To

change a parameter, type the new value into the field or select it from the list, and

then click Submit Changes at the bottom of the page to send the changes to the

iTap Port Aggregator device.

Note: ____________________________________________________________________

If you receive a message saying that your browser needs to resend the information

when you try to refresh your browser, return to the main Web Browser page by

re-entering the iTap Port Aggregator IP address in the browser's address bar.

Otherwise, you may not see current data when you refresh the browser. This

condition occurs only if you are looking at the "index.zhtml" page (for instance,

http://192.168.1.2/index.zhtml) that comes up after you Submit Changes.

__________________________________________________________________________

Figure 15: iTap Configuration (bottom part of Web Manager page)