Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 49)

iTap 10 GigaBit Port Aggregator
45
The following table describes the status fields.
Field Name Value Description
System Status UP/DOWN DOWN indicates an internal error; call Net
Optics Customer Service for assistance
System Model 10G 62.5um
SR Inline
Identifies the device model
Power Supply 1
Status
ON/OFF Indicates whether the iTap Port Aggregator is
receiving power from Power Supply 1
Power Supply 2
Status
ON/OFF Indicates whether the iTap Port Aggregator is
receiving power from Power Supply 2
Link Status UP/DOWN Indicates the state of the communication on the
port
Peak Rate (%) Highest utilization since last reset
Peak Date & Time mm/dd/
yyyy
hr:min:sec
When the peak rate occurred
Current Utilization
Rate (%)
Utilization level of the port bandwidth (incoming
traffic on Network Ports, outgoing traffic on Moni-
tor Ports)
Total Packets Total packets received
Total Bytes Total bytes received
CRC Errors Number of CRC errors
Oversize Packets Number of oversize packets
Configure an iTap Port Aggregator
Use System Manager's Configure tab to set configuration parameters of an iTap
Port Aggregator.
To configure the iTap Port Aggregator:
1. Select the device you want to configure by clicking its icon in the System
Frame.
2. Click the Configure tab. The configuration information appears.