Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 45)

iTap 10 GigaBit Port Aggregator
41
4. Enter the IP address of the iTap device in the IP Address text box. Be certain
that the IP address is unique on the network.
5. Enter any relevant information about the iTap device in the Notes text box.
6. Check your settings and click Create. The device appears in the System Manger
system frame.
Figure 21: Net Optics System Manager with a device
The indicator to the right of the iTap device picture blinks green when System
Manager is communicating with the iTap device. If the indicator blinks red for
more than a minute, check that the iTap device is connected to the network and
verify the configuration information.
Repeat this procedure for each iTap device you wish to add.
Tip! _____________________________________________________________________
To change the display order of iTap devices, click and drag them into the desired
order.
__________________________________________________________________________