Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 16)

iTap 10 GigaBit Port Aggregator
12
Configure the iTap Port Aggregator using the CLI
You should be logged into the iTap Port Aggregator CLI. The factory-set default
values for this iTap Port Aggregator are:
Username: netoptics
Password: netoptics
IP Address: 192.168.1.2
Netmask: 255.0.0.0
Display: ON
Management Port: ON
RX Threshold A: 50%
RX Threshold B: 50%
TX Threshold 1: 50%
TX Threshold 2: 50%
Port 1 Mode: AGG
Port 2 Mode: AGG
Port 1 Enable: ON
Port 2 Enable: ON
Port 1 CRC Regen: OFF
Port 2 CRC Regen: OFF
Port A Max Packet Size: 1518
Port B Max Packet Size: 1518
Port A TimeStamps: OFF
Port B TimeStamps: OFF
Port A Drop Bad Packet: OFF
Port B Drop Bad Packet: OFF
Port A Packet Slice: OFF
Port B Packet Slice: OFF
Port A Slice Size: 64
Port B Slice Size: 64