Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 19)

iTap 10 GigaBit Port Aggregator
15
View Current Settings
To view the current settings:
• Enter show set 1 and show set 2. The CLI displays the current settings; it will
be similar to the example shown on the following page.
NetOptics: show set 1
Model: 10G 62.5um SR Inline
System Time: 05/08/2008 11:29:42
IP Address: 192.168.1.2
Netmask: 255.0.0.0
Manager: 192.168.0.1
Gateway: 10.0.0.1
Port 1 Enable: ON
Port 2 Enable: ON
Display: ON
Management Port: ON
RX Threshold A: 50
RX Threshold B: 50
TX Threshold 1: 50
TX Threshold 2: 50
NetOptics: show set 2
Port 1 Mode: AGG
Port 2 Mode: AGG
Port 1 CRC Regen: OFF
Port 2 CRC Regen: OFF
Port A Max Packet Size: 1518
Port B Max Packet Size: 1518
Port A TimeStamps: OFF
Port B TimeStamps: OFF
Port A Drop Bad Packet: OFF
Port B Drop Bad Packet: OFF
Port A Packet Slice: OFF
Port B Packet Slice: OFF
Port A Slice Size: 64
Port B Slice Size: 64
Figure 6: Show Set command example
Tip! _____________________________________________________________________
Simply entering show set will display all of the settings at once; however, some of
the settings may scroll off your screen because the list is long.
__________________________________________________________________________