dbx PMC16 - Manual (Page 50)

PMC 16 Owner’s Manual 44
Using The Solo Function
Soloing channels allows the user to focus on specific channels for editing. Solo states
are global and are not stored to presets. They are, however, retained after a power cycle.
To solo/unsolo channels:
1. Select the channel(s) and/or group(s) which you would like to solo, using the
button(s) (the LED on the top of the selected Channel
Select button(s) will light green, indicating your selection).
2. Press the button to solo the selected channel(s). The Status LED
on the bottom of the selected Channel Select button(s) will light amber,
indicating the channel is soloed.
3. Repeat steps 1-2 to solo additional channels, if necessary.
4. To unsolo channels, press the button(s) for the
channel(s) in which you would like to unsolo, then press the button.
To unsolo all channels quickly, use the Clear function.
ActivAtiNg groups:
To enable the Group function and solo/unsolo all channels
within a group, press the button then perform the above steps.
Note:
Multiple channels can be selected for soloing using the PMC16’s Multi-Select
feature (see “Using Multi-Select”). Conversely, the button can also be pressed
and held, allowing multiple channels to be quickly soloed using the channel’s
SELECT> buttons.