dbx PMC16 - Manual (Page 34)

PMC 16 Owner’s Manual 28
Setup Wizard Options
When using the Setup Wizard, the system engineer can either run through the entire
Setup Wizard or run through individual Wizard options. Typically, the “RUN ALL SETUP
ITEMS” option would be used to initially create a configuration. The other options would
be used when creating a new configuration with only minor changes, such as changing the
Reverb Type or Input Setup. The Setup Wizard consists of the following options:
RUN ALL SETUP ITEMS
This option allows you to run through the entire Setup Wizard, which consists of all
Setup Wizard options listed below. Use this option to initially configure the PMC16. When
selecting this option, you will receive a prompt allowing you to select which mixer settings
(i.e. levels, pans, and effect send levels) you would like to start with. The options are:
• CURRENT SETTINGS–Select this option to retain the mixer level, pan, and
effect send level settings of the currently loaded preset.
• DEFAULT SETTINGS–Select this option to set all mixer settings to the defaults,
which are: levels=0 dB, pans=center, and effect send levels=-6 dB.
• PRESET–Select this option to load the mixer level, pan, and effect send level
settings from another stored preset.
INPUT SETUP
This option allows you to route the desired BLU link channels to the PMC16’s inputs.
When selecting this option, you will receive a prompt allowing you to select between the
following options:
• TR1616–Select this option when all BLU link channels being fed to the PMC16’s
inputs will be coming from a single TR1616.