PowerWalker Battery pack for VFI 10000P_RT LCD - Manual (Page 64)

60
Installation procedure:
Connected by USB to a PC or notebook, the Software enables
communication between the UPS and the computer. The UPS
software monitors the status of the UPS, shuts down the system
before the UPS is exhausted and can remotely observe the UPS via
the Network (enabling users to manage their system more
effectively). Upon AC failure or UPS battery low, UPS takes all
necessary actions without intervention from the system administrator.
In addition to automatic file saving and system shut-down functions, it
can also send warning messages via pager, e-mail etc.
•
Use the bundled CD and follow the on-screen instructions to
install the software WinPower.
•
Enter the following serial No. to install software:
511C1-01220-0100-478DF2A
•
After the software is successfully installed, the communication
with UPS has been established and an green icon will appear
in the system tray.
•
Double-click the icon to use the monitor software (as above).
•
You can schedule UPS shutdown/start-up and monitor UPS
status through PC.
•
Detail instructions please refer to the e-manual in the software.
9.4 REPO Function
The Remote Emergence Power Off interface provides an emergence
power off function. When the REPO function is enabled, once the EPO
port is pulled out, the UPS would shut off the output and enter into EPO
mode, and the UPS would not respond anything command unless the
port is plugged back.
614-08051-01
Check www.powerwalker.com/winpower.html from time to
time to get the latest version of monitoring software.