B&B Electronics ZP9D-115RM-LR - Manual User Manual
Page 47
Manual Documentation Number: ZP9D-115RM-LR-0812
47
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
SH (Serial Number High)
Command
used to set/read the serial
number high word of the RF
module.
SL (Serial Number Low)
Command
used to set/read the serial
number low word of the RF
module.
SM (Sleep Mode) Command
SM Command is used to
set/read the RF module's Sleep
Mode settings that configure the
module to run in states that
require minimal power
consumption.
AT Command: ATSH
Binary Command: 0x25 (37 decimal)
Parameter Range (read-only): 0 - 0xFFFF
Default Parameter Value: varies
Number of bytes returned: 2
Related Commands: SL (Serial Number Low)
AT Command: ATSL
Binary Command: 0x26 (38 decimal)
Parameter Range (read-only):
0 - 0xFFFF
Default Parameter Value: varies
Number of bytes returned: 2
Related Commands: SH (Serial Number High)
AT
Command:
ATSM
Binary Command: 0x01
Parameter Range: 0 - 8 (3 is reserved)
Parameter
Configuration
0
Disabled
1
Pin Sleep
2
Serial Port Sleep
3
[reserved]
4
Cyclic 1.0 second sleep
(RF module wakes every
1.0 seconds)
5
Cyclic 2.0 second sleep
6
Cyclic 4.0 second sleep
7
Cyclic 8.0 second sleep
8
Cyclic 16.0 second sleep
Default Parameter Value:
0
Number of bytes returned: 1
Related Commands: Pin Sleep - PC (Power-up
Mode), PW (Pin Wake-up) Serial Port Sleep -
ST (Time before Sleep) Cyclic Sleep - ST (Time
before Sleep), LH (Wake-up Initializer Timer),
HT (Time Before Wake-up Initializer), PW (Pin
Wake-up)