B&B Electronics ZP9D-115RM-LR - Manual - Manual (Page 23)

Manual Documentation Number: ZP9D-115RM-LR-0812 23
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Binary Commands
To Send Binary Commands:
Note: CTS (pin 9) is high when a command is being executed. Hardware
flow control must be disabled as CTS will hold off parameter bytes.
Example: Use binary commands to change the RF module's destination address to
0x1A0D and save the new address to non-volatile memory.
1.
RT Command must be set to '1' in AT Command Mode to enable binary
programming.
2. Assert CMD (Pin 10 is driven high). (Enter Binary Command Mode)
3. Send Bytes [parameter bytes must be 2 bytes long]:
00 (Send DT (Destination Address) Command)
0D (Least significant byte of parameter bytes)
1A (Most significant byte of parameter bytes)
08 (Send WR (Write) Command)
4. De-assert CMD (pin 10 is driven low). (Exit Binary Command Mode)