Cobalt Digital COMPASS 9220 Bidirectional ASI_MPTS Gateway - Manual (Page 53)

53 9220-UM V1.1
Pre-defined Templates
The 9220 offers 5 pre-defined configuration templates, as indicated below.
To load a template, just click on the Load button next to it. The pre-defined templates are;
•
6 ASI in
ψ ψ ψ ψ 6 IP out (GbE 1): This template configures all six ASI Ports as inputs, and
connects them to six IP Outputs on Ethernet Port 1.
•
6 ASI in
ψ ψ ψ ψ 6 IP out (GbE 2): This template configures all six ASI Ports as inputs, and
connects them to six IP Outputs on Ethernet Port 2.
•
6 IP in (GbE 1)
ψ ψ ψ ψ 6 ASI out: This template configures all six ASI Ports as outputs, and
connects them to six IP Inputs from Ethernet Port 1.
•
6 IP in (GbE 2)
ψ ψ ψ ψ 6 ASI out: This template configures all six ASI Ports as outputs, and
connects them to six IP Inputs from Ethernet Port 2.
•
3 IP In(GbE 2)
ψ ψ ψ ψASI out, 3 ASIψ ψ ψ ψIP out(GbE 1): This template configures the first
three ASI Ports as outputs, and connects them to three IP Inputs from Ethernet Port 2. It
configures the remaining ASI Ports as inputs, and connects them to three IP Outputs on
Ethernet Port 1.
Clear Current Configuration Button
The Clear Current Configuration button clears all the configured ports and streams as follows:
•
All ASI Ports are disabled.
•
All IP Inputs are deleted.
•
All IP Outputs are deleted.
•
All Connections are removed.
•
The Test Packet Generator is disabled.
The button does not affect the following areas:
•
The settings in the Network tab are not changed.
•
The settings in the Admin General tab are not changed.
•
Saved configurations are not modified in any way.
Dashboard™ will take a few seconds to reload (longer if you are accessing over a wide-area
network), but the actual configuration in the 9220 is virtually instantaneous. The Status Message
Area will indicate the result of the operation.