Baron Lighting & License_ULTIMATE LIGHT BAR User Manual

Page 4

Page: 4

BA-3006-00
ULTIMATE LIGHTBAR - Universal Fitment

Lamps can be adjusted by the set screws in the lower side of the assembly.

NOTE: The Halogen bulbs in this light bar get very hot! Do not touch them when they are on. Bulbs are 50-watt
driving and 20-watt turn signal - you should NOT replace with bulbs of higher wattage. Contact us for
replacement bulbs.

Simple trouble shooting tips:

Blows fuse when turn signal is on...Bare wire is touching the inside of the lamp or bar
Blows fuse when low-beam is on...Bare wire is touching the inside of the lamp or bar
Both turn signals blink together...Poor ground - make sure the bar and lamp assembly is secure to the bike
and is not insulated from the chassis. Also make sure the black wires from both sides of the light bar are
grounded.
Battery dies quickly...Dont forget to TURN OFF THE LIGHTS. These lights require a large amount of
power to run. At long periods of idle, and even short periods with the key on and the bike running, they
will drain your battery! Remember to turn them off when you shut the bike down.
Battery dies quickly...Install the optional mini-switch. Make sure to install the switch in-line between both
driving lights, and not the turn signals. You may need to wire the power leads together to the switch, and
then split them off again after the switch. Baron does not recommend running both lights from one power
lead.

Photo AA - Honda

Photo BB - Yamaha

Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or

fitment may be required. Barons bears no responsibility on installation costs associated with this product.

5221 Oceanus Drive

Huntington Beach, CA 92649

(925)583-2499 - Ph.

(714)901-0520 - Fax

www.baronscustom.com

[email protected]