Baron Tools_Oil Drain Tool - Billet Aluminum - For 09+ Touring Models - Manual

DRAG SPECIALTIES
OIL DRAIN ADAPTER
P/N 0712-0314
INSTALLATION INSTRUCTIONS
NEW 12/2010 Page 1 of 1
3501 Kennedy Rd, PO Box 5222, Janesville, WI 53547-5222
P/N 0712-0314
ATTENTION INSTALLER (if other than owner):
Please forward this Instruction Sheet to the purchaser
of this product. These instructions contain valuable
information necessary to the end user.
INTRODUCTION: These instructions describe the
procedure for properly installing and using the Oil Drain
Adapter on the 2009-2011 Touring models.
Review instructions carefully before beginning, as they
contain important information. Please retain for
future reference.
Particularly important information is distinguished in these
instructions by the following notations.
NOTE: A NOTE provides key information to make
procedures easier or clearer.
CAUTION: A CAUTION Indicates special procedures that
must be followed to avoid injury to a motorcycle operator
or person inspecting or repairing the motorcycle.
WARNING!: A WARNING indicates special procedures
that must be followed to avoid injury to a motorcycle
operator or person inspecting or repairing the motorcycle.
NOTE: This tool allows you to drain the oil out of the oil tank
without the oil running all over the cross-over plate on the
bottom of the frame.
PROCEDURE:
1. Place the motorcycle in a secure upright position. We
suggest using a lift on the frame that allows the engine oil
drain plug to be exposed.
2. Using the 5/8” socket
and ratchet, loosen the
drain plug on the bottom
of the oil pan.
3. Insert the adapter
through the hole in the
crossover plate and
locate it over the
drain plug.
4. Rotate the adapter
counter-clockwise (to the
left) to engage the lug on
the side of the adapter
with the lip on the cutout
in the crossover plate.
5. Confirm that you have an
even seal around the top
of the adapter and the
oil pan.
6. Remove the drain plug
with the ¼” hex bit and
ratchet with extension.
7. Allow the oil to drain
through the center of
the adapter and into the
drain pan.
8. Allow all oil to drain out of the oil pan.
9. Re-insert the drain plug and tighten finger tight.
10. Remove the oil drain adapter.
11. Tighten the drain plug to 14-21 ft-lbs.
12. Install the proper amount of oil in the oil tank.
WARNING!: Before operating motorcycle, be sure all hardware
is tight.